Manufacturers

Blueridge Motorsports

Brian Crower

Bullseye Power Turbos

Competition Clutch

Drive Shaft Shop

D2 Racing

Fluidampr

Hondata

Innovative Mounts

Omni Power

RC Engineering

RLZ Heads

More Manufacturers





Subscribe to our newsletter and specials!









 
 

 

  ETD Swivel Neck Thermostat Housing K-24 KST-24-253
ETD Swivel Neck Thermostat Housing K-24 KST-24-253


 
Alternative Views:
Our Price: $168.00



Availability:: Usually Ships in 24 to 48 Hours
Product Code: KST-24-253
Qty:

Description
 
ETD Swivel Neck Thermostat Housing K-24 KST-24-253
Features
  • K-Tuned has the solution to your lower rad hose problems. Some of the motors we have received came with the oem plastic water neck broken. Until now, you could only order a replacement part from Honda/Acura. Problem is they only sell the housing complete with the thermostat, which is pretty expensive and it doesn’t provide any real benefits. If your housing isn’t broken then you still have to get the right hose, with the right angles and mate it to the rad. After that, you have to figure out where to put your fan switch and in the past the only option was to use a special inline aluminum hose adapter.
  • This product solves all these problems and gives you some options when doing your swap. The housing swivels, allowing you to position the water outlet angle before it is tightened down. The provided custom made fitting is the same size as the oem rad hose on one end, and is threaded for an AN fitting on the other end. This allows you to use whatever size fitting you need for custom installations. If you want to use braided hose with AN fittings, this housing will bolt on easily and with the right adapter threaded in, you’ll be all set. The housing has three ports in the body, one for your fan switch and two auxiliary 1/8 NPT ports for gauges etc. It comes pre-assembled with a quality Stant thermostat (195 deg.) which is held in place with a "C" clip. The kit uses a standard size thermostat that you can easily replace with anything in the 160-195deg. range.
  • Last but not least, this was a bonus we found while designing it. We noticed that by adding one more hole to the flange you could completely remove the oem black plastic housing from the block and delete the heater core hoses. When set up this way, our thermostat housing is bolted directly to the oem aluminum water pump housing. This is perfect for race car applications.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

More Manufacturers > K-Tuned


ETD Stabilizer Arm Kit 88-91 Civic CRX 8891-STAB-01
ETD RSX Fuel Rail (silver, w fittings oem lines) KRS-RSX-304
ETD RSX Fuel Rail (black, w fittings oem lines) KRB-RSX-305
ETD RBC Cold Air Intake EG DC2 EK K-RSI-322
ETD Stabilizer Arm Kit 88-91 Civic CRX 8891-STAB-01
ETD RSX Fuel Rail (silver, w fittings oem lines) KRS-RSX-304
ETD RSX Fuel Rail (black, w fittings oem lines) KRB-RSX-305
ETD RBC Cold Air Intake EG DC2 EK K-RSI-322
$149.00
$129.00
$139.00
$179.00